XL 650 Build
Quote from Reloader on July 2, 2011, 5:37 pmI'm putting my 650 together 1st time. The handle won't completely go up, meaning that the plate won't go completely down. The primer plunger doesn't go far enough down to even engage. I cannot see why the plate stops, but it does. Frustrating!!!! Thoughts?
I'm putting my 650 together 1st time. The handle won't completely go up, meaning that the plate won't go completely down. The primer plunger doesn't go far enough down to even engage. I cannot see why the plate stops, but it does. Frustrating!!!! Thoughts?
Quote from Reloader on July 3, 2011, 3:38 pmThe outside edge of the Chute/Bin Mount was a little too wide and was making contact with the Case Insert slide. There is no way this machine was tested as stated, as it would not allow a case to slide all the way in, and would not allow the primer pin to raise. At least I found it.
The outside edge of the Chute/Bin Mount was a little too wide and was making contact with the Case Insert slide. There is no way this machine was tested as stated, as it would not allow a case to slide all the way in, and would not allow the primer pin to raise. At least I found it.