XL650 Ejector Wire Problem
Quote from dichione@earthlink.net on February 16, 2024, 4:27 pmI've seen all the recommendations on how to fix the ejection wire problem. However, when reloading 9mm / 380 ACP, the loaded round does not always eject properly about 20% of the time. This is very frustrating and has been a continuous problem for many years. Can Dillon address this problem by re-designing this system? There must be a better way.
I've seen all the recommendations on how to fix the ejection wire problem. However, when reloading 9mm / 380 ACP, the loaded round does not always eject properly about 20% of the time. This is very frustrating and has been a continuous problem for many years. Can Dillon address this problem by re-designing this system? There must be a better way.
Quote from ARMTGuy on February 16, 2024, 4:57 pmThe 750/650 ejector wire was redesigned years ago. In our experience, running the shellplate bolt too loose is the most likely cause. Check for this by pushing down on the edge of the shellplate at station 4. If it feels springy, then the shellplate bolt needs to be slightly tighter.
The 750/650 ejector wire was redesigned years ago. In our experience, running the shellplate bolt too loose is the most likely cause. Check for this by pushing down on the edge of the shellplate at station 4. If it feels springy, then the shellplate bolt needs to be slightly tighter.
Quote from neloril804@ on October 12, 2026, 11:44 am성동 이동권, 마감 시간, 관리 시간, 요금 기준 기준을 한눈에 비교해 문의 전 필요한 핵심 조건을 빠르게 파악하도록 정리한 러시아마사지 안내입니다러시아마사지
성동 이동권, 마감 시간, 관리 시간, 요금 기준 기준을 한눈에 비교해 문의 전 필요한 핵심 조건을 빠르게 파악하도록 정리한 러시아마사지 안내입니다러시아마사지