Mr. Bullet Feeder does not work properly on XL750?
Quote from Reloader on August 6, 2020, 9:59 pmI can confirm that with the short DAA powder bar installed in the XL750 you can run the Mr. Bulletfeeder in station 4 with the Dillon Powder check in Station 3. (Assuming you have a seat/crimp combo die in station 5). There is now enough clearance. Double Alpha just needs to update their documentation and website with regard to the XL750. I got it setup today and I'm happy with the results.
I can confirm that with the short DAA powder bar installed in the XL750 you can run the Mr. Bulletfeeder in station 4 with the Dillon Powder check in Station 3. (Assuming you have a seat/crimp combo die in station 5). There is now enough clearance. Double Alpha just needs to update their documentation and website with regard to the XL750. I got it setup today and I'm happy with the results.
Quote from Reloader on September 27, 2020, 7:01 ami have the short one and it works.
but i did email them about a large one here is what they said.Double-Alpha Sales
Mon, Sep 14, 1:59 PM (13 days ago)
to meHI Glenn,
I hope this finds you well.
Unfortunately, at the moment we do not have plans to release a large version.
Regards,
Josh Lentz
Sales & Technical Support
Alpha Dynamics USA
2908 Betz Court
Orefield, PA 18069
Tel: (610) 366-9752
i have the short one and it works.
but i did email them about a large one here is what they said.
Double-Alpha Sales
Mon, Sep 14, 1:59 PM (13 days ago)
to me
HI Glenn,
I hope this finds you well.
Unfortunately, at the moment we do not have plans to release a large version.
Regards,
Josh Lentz
Sales & Technical Support
Alpha Dynamics USA
2908 Betz Court
Orefield, PA 18069
Tel: (610) 366-9752
Quote from Reloader on October 26, 2020, 6:53 pmSo i fixed this just by rotating the powder drop so the bar was out of the way, and then running a straight rod to actuate the powder drop with a 3d printed clevis (just because I didn't want to pay shipping on a $2 part from mcmaster-carr)... I don't see why dillon just doesn't change their design to this?
see images -> https://imgur.com/a/jkOGlN3
So i fixed this just by rotating the powder drop so the bar was out of the way, and then running a straight rod to actuate the powder drop with a 3d printed clevis (just because I didn't want to pay shipping on a $2 part from mcmaster-carr)... I don't see why dillon just doesn't change their design to this?
see images -> https://imgur.com/a/jkOGlN3